***
*** PLEASE REMEMBER: Always reboot the device first before you proceed with firmware upgrade.
***

The firmware file in this archive (OSWave_2.34R.bin) can be used to upgrade any device, regardless of hardware version,
that is already running OSWave system.

2008-11-26 Version 2.24R <firmware@oswave.com>

- Added Spectrum Analyzer feature.
- Added IP Alias in bridge mode.
- Fixed SNMP readings bugs.
- Fixed VTUN client to support SSL libraries.
- Added Channel Scan Range for client modes.
- Fixed WPA operation for dual radio boards.
- Added option to define Management VLAN ID for device management.
- Added option to tag all traffic with specific VLAN ID.
- Added option to filter specific VLAN IDs.
- Fixed missing antenna selection option for NS2 devices.

2009-02-09 Version 2.27R <firmware@oswave.com>

- Added support for Engenius EOC-2610.
- Fixed problem with setting low transmit power values.

2009-03-29 Version 2.30R <firmware@oswave.com>

- Added support for Engenius EOC-5610.
- Added option to disable PPPoE relay in router/NAT router mode.
- Fixed problem in client mode with WPA enabled where device sometimes didn't forward ARP packets properly.
- Fixed WEB GUI problem on D-Link DIR-300 that prevented changes on Advanced Settings page.

2009-06-18 Version 2.34R <firmware@oswave.com>

- Fixed SNMP noise level reporting in PtP Bridge mode.
- Added automatic system information page update.
- Fixed device MAC address display in Dynamic WDS mode.
- Addedd XTRange.
- Added SNMP associated stations reporting in Access Point mode.
- Fixed WPA encryption issues when operating in PtP Bridge mode.
- Fixed association problems sometimes occuring when using 5MHz or 10MHz channel width in 2.4GHz mode.